Product Notes

• Per HP, using ECC UDIMMs the DL360 G7 supports up to 48GB of memory.
• There are eighteen (18) memory slots.
• There are three (3) channels per processor; six (6) channels per server.
• There are three (3) DIMM slots for each memory channel; eighteen (18) total slots.
• Memory channel 1 consists of the three (3) DIMMs that are closest to the processor.
• Memory channel 3 consists of the three (3) DIMMs that are furthest from the processor.
• DIMM slots that are white should be populated first.
• Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs).
• Do not install DIMMs if the corresponding processor is not installed.
• If only one processor is installed in a 2CPU system, only half of the DIMM slots are available.
• To maximize performance, balance the total memory capacity between all installed processors.
• It is not required, but it is recommended to load the channels similarly if possible.
• You can only have up to eight (8) ranks installed per channel.
• You can only install two quad-rank DIMMs per channel.
• You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty.
• Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel.
• Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset.
• For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically.
• For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs. The paired slots will be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system.
• Low Voltage DIMMs can only be used with Intel® Xeon® processor 5600 series processors.
• If mixing DIMM voltage is a requirement, please note that the DIMMs will run at 1.5V since all 1.35V are capable of supporting 1.5V operations.